Nissan GT-R Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 33 Results
  1. Engine
    Hi I upgraded my OEM BOVs to Turbosmart BOVs and running them on softest setting. I am noticing a SLIGHT lag between gears. Before, the car used to just gooo once I put my foot down. Now it feels like a slight delay before it goes. Does anyone here with turbosmart or any Bovs have the same...
  2. Engine
    I did 3 pulls yesterday with full pedal pressed and R/C/VDC off and once the car reaches exactly 183kmh (114mph) it just gets stuck .. and won't go over. No CEL or limp safety appeared. It's weird because i've been over 170mph a couple of times before... in mexico, with no issues. Sent the...
  3. AccessTUNER
    I always like to have the AP active whenever I'm driving. Especially when I had issues with my previous tune throwing codes and limp safety. I do the 6 view layout: Boost RPM Limp status Dynamic Adv. STFT B1,B2 What's yours and what do you like to monitor the most?
  4. R35 GT-R
    Hi guys, I recently purchased a set of the Boost Logic Titanium Intakes with the blue finishing and I wanted to share my experience so far. I drive a 2011 FBO GTR. The car is great and love every single peace of it.. but I always felt like something was missing. Here is where Boost Logic came...
  5. Engine
    Hey guys, I recently drove my car on the freeway for the first time since I picked it up after a repair (dent, oil cooler and inlet pipe replaced), and I am having problems accelerating. The car will not accelerate past about 3-4000 RPMs, and on the freeway the maximum speed I could achieve was...
  6. Engine
    Hi GTR community! I have a question. Just looked at my logs and noticed that boost is dropping down from 17 to 14 psi when RPM reaches the red line (although wastegate duty stays 100%). Heard that replacing stock turbo actuators will help to hold boost constant. Will it be safe and how will it...
  7. Engine
    What do people think is a safe boost in psi for a stock motor. I track regularly and run 14psi with Cobb AP. I have only changed to this tune a month ago. I have aftermarket midpipe and muffler.
  8. R35 GT-R
    Thanksgiving is upon us and that means Black Friday deals are back again! We're offering 10% off our entire site along with HUGE DISCOUNTS UP TO 50% OFF our GTR lineup throughout this Thanksgiving Weekend. From our Titanium F16 Exhaust Tips, to our Race Style Intercoolers, we've got your car...
  9. Engine & Transmission
    I am selling a pair of 1 bar wastegate actuators for stock or stock manifold turbos. They have about 2k miles on them. They worked flawlessly when taken off. Only selling because I need the stronger 1.4 bar actuators to hold 30+ psi on my upgraded stock manifold turbos. These had no problem at...
  10. Engine
    Ok, so the other week i installed a set of boostlogic 3" upper IC pipes with Tial BOVs on my 2011. I did some logs afterwards and noticed that i am only making about 16.5psi of boost on an 18psi map. I have looked for boost leaks, checked all the couplers and vacuum hoses and everything looks...
  11. AccessTUNER
    I couldnt contain my excitement any longer. I had the Cobb sitting on my dresser for a week while I lamented whether to install it on my 2014 and risk losing my warranty. I finally decided to bite the bullet and install it. Afterall, this was why I bought the car in the 1st place and I wanted to...
  12. Engine
    My car is a 2009 with cobb 2.75 intakes, Accessport ots map ( i have tried many different ones), midpipe and boost logic boost solenoid. The car was running great until the dreaded flashing boost gauge. Am I starving the engine of fuel? I have put fresh gas and octane boost. I get knock sums...
  13. California
    Selling my AAM 1600R kit. Comes complete with all lines etc. all black heat coated. Kit has less than 1500 miles on it. I was able to make one pass with it at the drag strip and it was a 8.74 @ 160 with a street cooler and oem intake manifold. definitely capable of mid lower 8's. we never got a...
  14. California
    Hey Guys, Selling my AAM 1600R kit. Comes complete with all lines etc. all black heat coated. Kit has less than 1500 miles on it. I was able to make one pass with it at the drag strip and it was a 8.74 @ 160 with a street cooler and oem intake manifold. definitely capable of mid lower 8's. we...
  15. WTB
    Was wondering if any of you guys has a good OEM Bosst Control Solenoid laying around that you would like to sell. I beleive it's P/N 14956-JF00A. I do not know what these are selling for used. My contact info is: email- [email protected] cel:786-975-8660 I'm located in Miami and would need it...
  16. Engine
    I need some help from my fellow forum members. I have a 2009 with Y-pipe, K&N filters (stock airboxes) and V2 Accessport with BETA Stage 2 93 OCT calibration. No matter what map slot I'm in my car doesn't produce more boost than 11 psi at best. It usually around 8.5 psi. Can anyone advise...
  17. R35 GT-R
    Got a 900whp GT-R was at the track last night for the first time trying to get the tires to hook up have drag radios on the front and slicks on the rear I leave on 5 pounds of boost it jumps out and then falls flat on it's face Dan hits and takes off
  18. Exterior & Interior
    For Sale - Brand new DBA Front Lip/chin/splitter Details - Brand new DBA Front Lip/chin/splitter Fits 2012+ GTR, or you are able to fit if you are doing a CBA-DBA conversion. Retail sells for approximately $1200. All wrapped and ready to ship, as you can see from the pictures original packaging...
1-20 of 33 Results
Top