Nissan GT-R Forum banner
pistons
1-6 of 6 Results
  1. R35 GT-R
    I have heard of a few motors going in GTR's over the years and a quite a few of those times reported from the owner it wasn't during racing or wide open throttle. It was merely just cruising along and a catastrophic failure occurs at very little load. Does anybody know of the science behind...
  2. R35 GT-R
    For Immediate Release: TSM is very very proud to announce the release of our exclusive Nissan GT-R piston and rod combination. As many of you know we have been building VR38DETT engines for years now and frankly have tried about every combination of rotating assembly available on the market...
  3. Engine
    Hi everyone, I'm new to the forums, but have owned an 09 for a couple years. I would like to build my own engine and would like some recommendations regarding components. My build will not exceed 1000whp, my target is actually 900whp. I'm also looking for a tear down / torque spec manual. Nissan...
  4. Engine & Drivetrain
    Build it before you blow it. Here are a few parts from CP, Carillo, JE, and Ferrea for you GTR guys that want to build your VR38. I will be adding more parts from time to time be sure to check back every now and then. If you need anything you don't see don't hesitate to ask. If you have any...
  5. Engine & Drivetrain
    JE Pistons for 2009 and Up Nissan GTR VR38DETT 95.5mm Bore 9.0 CR - 297681 Only have 1 set in stock - $800.00 Shipped to all lower 48 states. JE has a reputable history of manufacturing high performance forged pistons. Engine builders from NASCAR, ALMS, NHRA, AMA Supercross, and others...
1-6 of 6 Results
Top