Nissan GT-R Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter · #1 ·
I just bought a used 006 Accessport and tried to install it on my car, apparently the previous owner did not unmarry his accessport from my car so the new AP said "a previous tune was installed, continuing will erase all data, do you want to continue" I select YES, and everything is going to plan. I can see all maps on the AP, when I go to upload the map it says. "Drive cycle must be performed, vehicle conditions not met to perform install".. WTF??? Vehicle was fully warmed up, coolant temp was 185 deg, TCM was at 154 deg.

Will it not write over the existing AP tunes from the previous owners AP??

How can i get around this.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top