Nissan GT-R Forum banner
1 - 2 of 2 Posts

· Registered
461 Posts
Discussion Starter · #1 ·
Hey guys, I'm looking at ordering some wheels studs and spacers to use on my stock GTR wheels with stock nuts. Could somone a bit more inteligent than I am tell me if these will work? Thread is the same, but I'm not sure it the length is correct for a 15/20mm spacer. Thank you for the help


· 2009 R35 (GOD7ILLA)
392 Posts
Yes, those are the correct lugs.

You may find this useful.

I've run spacers up to 25mm using these lugs without issue.

You will still likely need new nuts though. The stock ones may thread on ok with the spacers in place, but it's possible the long stud will protrude too much to take the closed-end stock nut.

Most use a open-ended steel nut matched to their taste.

Re spacers, depending in how fussy you are, you may also find this useful...
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.