[Lutfalla R35]

While me and [email protected] were working on my car (e-tune) I was Flashing the map in the car after installing it in the accessport .. suddenly something went wrong and accessport and it stopped working .. It went to the Recovery mode and when i try to recover it says that this cobb isn't registered on this vehicle .. Now im stuck and cant continue working on the car

Any solutions or suggestions would be much appreciated

Video:

Mohamed

 

[thistle]

Call Cobb. Number is on their website front page.

 

[Lutfalla R35]

sent them plenty of emails .. no responed until now .. tried calling aswel today but no answer :S

ill upload a video now showing whats going on

 

[Lutfalla R35]

Video is up in the first post

 

[Ben Linney]

Mo don't worry this will get sorted one way or another. either with a firmware fix or might need a bench flash.

Rarely happens but something went wrong, maybe low battery, cable etc... strange as you were on revision map 8 all flashed ok

Joe is out of office but Will & co will advise shortly. no answer on phone as middle of the night.

 

[JoeGr]

I'll answer your email too, but what firmware are your running on your AccessPORT?

Joe

 

[Lutfalla R35]

Firmware version: V1.6.5.0-2884
Part num: AP-NIS-006
Serial: 557
Installation state: Recovery
Vehicle: Gulf Spec. 2009 GT-R Speed Density

I emailed you

 

[Lutfalla R35]

Firmware version: V1.6.5.0-2884
Part num: AP-NIS-006
Serial: 557
Installation state: Recovery
Vehicle: Gulf Spec. 2009 GT-R Speed Density

I emailed you

 

[Ben Linney]

fantastic support from Will Trang @ Cobb ! an alpha firmware update now see's a recovery state accessPORT flashing again

 

[Lutfalla R35]

+1

Ben, I've sent u logs bro