[Mr.nissan]

This is the third time I've had to do the drive shaft an bell housing it seems to be going out around every 17,000 miles of normal driving I'm thinking of asking dynotech engineering to make me a custom one any feed back on this would be great .

 

[kdahm]

Im by no means an expert but I've read a fair bit about the issue and ironically stumbled across Willall's shims this morning. Hopefully it helps on some level. http://www.willallracing.com.au/transmission.htm#wr35tsb

 

[Mr.nissan]

thanks bro

 

[Optherion]

Anyone installed these? I am having my bell housing replaced and maybe I should just install these when it is being done?

 

[livingit]

The drive shaft needs to to aligned perfectly or the bell housing will go bad very quickly..I have seen new ones with 1000 miles start vibrating and getting noisy. It's a big flaw in the design of Gtr imo.

 

[heacuva]

i've installed willall shims and aligned driveshaft. so far so good