Nissan GT-R Forum banner

Engine builds - who did you use

12K views 39 replies 17 participants last post by  TheAlpha 
You can go with Ronnie at RD Engineering in Oxnard or James Wie with ACG in San Diego. Both are good. I would not go to SP Engineering, although they built my engine and I have not had any issues with it. I had to replace the transmission and trubos, though.

RD uses a 30mm turbo setup to get close to 1200 at the wheels. That is a very fast spooling turbo. I have the elite prime turbos on my car which are 35mm turbos.
Damn 30mm and 35mm is pretty small.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top