Nissan GT-R Forum banner
1 - 15 of 15 Posts

·
Registered
Joined
·
3,967 Posts
Discussion Starter · #1 ·
Hi Everyone,

Ichiba has released the Version II of their spacers where the studs are already embedded into the spacer. I also used a digital caliper to measure and you can see it's 15mm to the thousandths.

Available in the following sizes:
5MM = 0.197 INCH
8MM = 0.313 INCH
10MM = 0.393 INCH
12MM = 0.473 INCH
15MM = 0.590 INCH
20MM = 0.787 INCH
25MM = 0.983 INCH

Prices start at $130/pair.









Let me know.

Michael
Owner
Acute Performance
 

·
Registered
Joined
·
39 Posts
Michael,

Do you know what the recommended torque value is for bolting these to the hub? And, is using thread lock such as blue Loctite advised?
Thanks
Karl
 

·
Registered
Joined
·
3,967 Posts
Discussion Starter · #6 ·
Loctite I wouldn't bother. Yes standard tq values as defined by Nissan -- this was also confirmed by Ichiba.
Did you need a set or do you have already?
 

·
Registered
Joined
·
39 Posts
I do already have a set but have found it real difficult to find info on fitting. I very much appreciate your help on this Michael.
Thanks
Karl
 

·
Registered
Joined
·
3,967 Posts
Discussion Starter · #8 ·
Hi Karl,

No problem that's what I'm here for to help out as much as I can. If you ever need anything please keep me in mind.

Michael
Owner
Acute Performance
 

·
Registered
Joined
·
12 Posts
i have these exact spacers and they dont fit on my front hubs,there is five thread bolts plus another bolt for something which stops the spacer going on,does the gtr ones have six holes to allow for this extra bolt?
 
1 - 15 of 15 Posts
Top